Skip to content

Deploy using Microsoft Hyper-V

The following steps will walk you through the deployment:

Info

The PAM Server must be deployed on a Generation 2 virtual machine.

  1. Within your existing Hyper-V infrastructure, create a new virtual machine with a custom configuration.

  2. On the Before You Begin screen click Next >.

    Before You Begin

  3. On the Specify Name and Location screen, enter the name and location based on your preferences and click Next >.

    Specify Name and Location

  4. On the Specify Generation screen, select Generation 1 and click Next >.

    Specify Generation

    Warning

    Do not select Generation 2 as it is not supported.

    Note

    When adding an external disk it must to be mounted to the IDE controller for it to work. For further information see File store.

  5. On the Assign Memory screen, set the Startup memory as 16384 MB, deselect the Use Dynamic Memory for this virtual machine and click Next >.

    Assign Memory

  6. On the Configure Networking screen, set the Connection based on your preferences and click Next >.

    Configure Networking

  7. On the Connect Virtual Hard Disk screen, select Use an existing virtual hard disk, browse to the download VHD file and click Next >.

    Connect Virtual Hard Disk

  8. On the Summary screen verify the details shown and click Finish.

    Summary Screen

  9. Wait while the virtual appliance is created.

  10. In the Virtual Machines list, right-click the new virtual appliance and click Settings....

    Machine List

  11. In Processor, assign 8 virtual processors to the virtual appliance.

    Set Virtual Processors

  12. In the Virtual Machines list, right-click the virtual appliance and select Start.

  13. Once started, right-click the virtual appliance and select Connect. The virtual machine will open in a window on your desktop.

  14. Once the servers have been successfully deployed and powered on the next step is to configure the server.